4DWC – Submersible Non-Clog Sewage Pump

Bell & Gossett : Wastewater Pumps & Packages : Sewage Wastewater Pumps

4DWC – Submersible Non-Clog Sewage Pump

Features and Benefits

  • Impeller: Cast iron, two vane closed design for high efficiency and maximum wear life. Balanced for smooth operation. Optional bronze impeller available.
  • Bronze Wear Ring: Replaceable to renew the running clearances and efficiencies to original conditions.
  • Casing: Heavy duty cast iron, volute type for maximum efficiency. 4″ ANSI 125 # cast iron flanged. Adaptable to guide rail system mounting.
  • Dual Mechanical Seals: Function independently for maximum motor protection. The failure of one seal does not affect the operation of the second. The upper seal uses carbon rotating and ni-resist stationary face materials. The lower seal uses carbon rotating and ceramic stationary face materials as s
  • Seal Sensor Probe: The pump has two moisture detection probes located in an oil filled seal chamber. If pumpage should leak past the lower seal the moisture detection circuit in the control panel indicates a fault has occurred. Requires an Optional Seal Fail or Moisture Detection Circuit in the cont
  • Designed for Continuous Operation: Motor is rated continuous duty submerged condition in water that is 40°C or below. Maximum runtime with pump unsubmerged for 71/2-15 HP is 1 hour and for 20-30 HP is 15 minutes. Motor is suitable for 10 starts per hour.
  • Bearings: Double row angular contact thrust bearing on 250TYS frame and single row deep groove thrust bearing on 210TY frame pumps.
  • Impeller Mounting Screw: 300 series stainless steel with antirotational locking patch.
  • Castings: All iron castings are ASTM A48 class 30 gray cast iron. Optional bronze impeller is ASTM B584 C87500 silicon bronze.

General Selection Tools:

  • ESP-PLUS for B&G Centrifugal Pumps, Booster Pumps, Pump Accessories, and Air Separator
  • ESP-PARTS for replacement parts selection
  • ESP-TANKS for replacement parts selection
  • CAD Drawings for 2D and 3D dimensional drawings in many formats

Heat Exchanger Product Selection

Steam + Water Pressure Reducing Values

Sizing Tools:

Report Bugs/Request Enhancements
Please email the following address to report issues and request enhancements: ebusiness.support@xyleminc.com

Consult your local Bell & Gossett Representative for additional assistance.

Regional Office:

Byblos Bank Center 1st Floor
Baabda Main Street
Lebanon
Tel.: +961-5-920401

Search below to find your local distributor. If there is no location found, please contact our regional office for more information.

Find your local distributor
Country