Hoffman Specialty Y-Strainers

Bell & Gossett : Steam Specialties : Strainers

Y Strainers are designed for steam, oil or water lines. Strainers should be installed ahead of temperature regulating and/or pressure reducing valves and steam traps to protect their moving parts from dirt, this is particularly important for new installations.

 

Screwed NPT End

Model 415C

  • Cast iron body
  • Maximum pressure:
    • 250 psig (17.3 bar) for steam service
    • 400 psig (27.6 bar) for water service
  • Available in sizes 1⁄2″ – 3″ NPT

Model 420C

  • Cast brass body
  • Maximum pressure:
    • 300 psig (20.6 bar) for steam service
    • 400 psig (27.6 bar) for water service
  • Available in sizes 1⁄2″ – 3″ NPT

 

Flanged End

Model 450C

  • Cast iron body
  • Maximum pressure:
    • 125 psig (8.6 bar) for steam
    • 200 psig (13.8 bar) for water
  • Available in sizes 2 1/2″ – 8″ (65-200mm)

Model 460A, 460B

  • Cast iron body
  • Maximum pressure:
    • 250 psig (17.3 bar) for steam
    • 500 psig (35 bar) for water
  • Available in sizes 2 1⁄2″ – 8″ (65-200mm)

Catalog Pages

    General Selection Tools:

    • ESP-PLUS for B&G Centrifugal Pumps, Booster Pumps, Pump Accessories, and Air Separator
    • ESP-PARTS for replacement parts selection
    • ESP-TANKS for replacement parts selection
    • CAD Drawings for 2D and 3D dimensional drawings in many formats

    Heat Exchanger Product Selection

    Steam + Water Pressure Reducing Values

    Sizing Tools:

    Report Bugs/Request Enhancements
    Please email the following address to report issues and request enhancements: ebusiness.support@xyleminc.com

    Consult your local Bell & Gossett Representative for additional assistance.

    Regional Office:

    Byblos Bank Center 1st Floor
    Baabda Main Street
    Lebanon
    Tel.: +961-5-920401

    Search below to find your local distributor. If there is no location found, please contact our regional office for more information.

    Find your local distributor
    Country