Well Tanks: Non-ASME Pre-Pressurized Tanks Series WTX

Bell & Gossett : Hydronic Heating/Plumbing Accessories : Tanks

The Series “WTX” tanks will help protect the pump and pressure switches against short cycling. The potable well tank delivers adequate water under pressure between pump cycles to meet the required demand. It will provide economical system operation by minimizing pump starts, extending pump motor life, and saving energy. The “WTX” tank will also assist the pump in meeting peak demands.

Residential/Commercial Applications

Features and Benefits

  • Designed for Well Water and Booster Pump Systems.
  • Minimize Pump Run Times, Extends Life of Pump
  • Polypropylene Liner Provides Corrosion Resistance
  • Butyl/EPDM Diaphragm Resistant to Bacterial Growth
  • FDA Approved Materials
  • Pre-pressurized to Most Common Cut-in Pressures
  • High Maximum Operating Temperature of 200ºF
  • High Maximum Working Pressure of 100 PSIG

General Selection Tools:

  • ESP-PLUS for B&G Centrifugal Pumps, Booster Pumps, Pump Accessories, and Air Separator
  • ESP-PARTS for replacement parts selection
  • ESP-TANKS for replacement parts selection
  • CAD Drawings for 2D and 3D dimensional drawings in many formats

Heat Exchanger Product Selection

Steam + Water Pressure Reducing Values

Sizing Tools:

Report Bugs/Request Enhancements
Please email the following address to report issues and request enhancements: ebusiness.support@xyleminc.com

Consult your local Bell & Gossett Representative for additional assistance.

Regional Office:

Byblos Bank Center 1st Floor
Baabda Main Street
Tel.: +961-5-920401

Search below to find your local distributor. If there is no location found, please contact our regional office for more information.

Find your local distributor