ASME Expansion Tanks – Series WTA Pre-Charged Tanks

Bell & Gossett : Hydronic Heating/Plumbing Accessories : Tanks

Designed for Potable Well Water and Booster Pump Systems.

The Series WTA expansion tank is an ASME constructed precharged vessel. The WTA tanks will help protect the pump and pressure switches against short cycling. The well tank delivers adequate water under pressure between pump cycles to meet the required demand. It will provide economical system operation by minimizing pump starts, extending the life of the pump motor, and saving energy. The WTA tank will also assist the pump in meeting peak demand.

Features and Benefits

  • ASME Construction
  • Minimize Pump Run Times, Extends Life of Pump
  • FDA Approved Materials
  • High Maximum Operating Temperatures
  • 125 PSI Maximum Working Pressure
  • Higher Working Pressures of 175 PSI and 250 PSI Available

General Selection Tools:

  • ESP-PLUS for B&G Centrifugal Pumps, Booster Pumps, Pump Accessories, and Air Separator
  • ESP-PARTS for replacement parts selection
  • ESP-TANKS for replacement parts selection
  • CAD Drawings for 2D and 3D dimensional drawings in many formats

Heat Exchanger Product Selection

Steam + Water Pressure Reducing Values

Sizing Tools:

Report Bugs/Request Enhancements
Please email the following address to report issues and request enhancements: ebusiness.support@xyleminc.com

Consult your local Bell & Gossett Representative for additional assistance.

Regional Office:

Byblos Bank Center 1st Floor
Baabda Main Street
Lebanon
Tel.: +961-5-920401

Search below to find your local distributor. If there is no location found, please contact our regional office for more information.

Find your local distributor
Country