The B&G Circuit Sensor Flow Meter is a precision machined wafer-type orifice insert that is installed between standard 125, 150, 250 or 300 psi ANSI flanges, to monitor system flow with a minimum friction head loss.
System flow is determined by obtaining a differential pressure across the flow meter orifice by sensing upstream and downstream pressures through the readout valves, then referring to the calibrated nameplate for the corresponding flow.

Circuit Sensor Flow Meters are suitable for a maximum operating temperature of 250°F (121° C), and are equipped with RV-125A Readout Valves fitted with an integral EPT check valve designed to minimize system fluid loss during the monitoring process.

General Selection Tools:

  • ESP-PLUS for B&G Centrifugal Pumps, Booster Pumps, Pump Accessories, and Air Separator
  • ESP-PARTS for replacement parts selection
  • ESP-TANKS for replacement parts selection
  • CAD Drawings for 2D and 3D dimensional drawings in many formats

Heat Exchanger Product Selection

Steam + Water Pressure Reducing Values

Sizing Tools:

Report Bugs/Request Enhancements
Please email the following address to report issues and request enhancements: ebusiness.support@xyleminc.com

Consult your local Bell & Gossett Representative for additional assistance.

Regional Office:

Byblos Bank Center 1st Floor
Baabda Main Street
Lebanon
Tel.: +961-5-920401

Search below to find your local distributor. If there is no location found, please contact our regional office for more information.

Find your local distributor
Country