Enhanced Air Separator
As system fluid enters through the inlet, (either straight or angle) the diffuser distributes flow evenly across the stainless steel, wire brush-like medium. Air bubbles, even micro air bubbles, stick to the brush filaments. Trapped air rises above the diffuser through a baffle where the air is then released through an opening at the top. Treated water then goes back into the system.
EAS is very easy and convenient to install:
- requires no minimum pipe run.
- straight or angle pattern installation capability.
- usable for systems with either steel compression or diaphragm expansion tanks.
- removable and replaceable ¾” high capacity vent.
EAS is built to last:
- rugged two-piece cast iron body and cap construction.
- internal parts are all stainless steel.
- vent has a brass body and non-ferrous internals.
Brochures
Technical Brochures
- Model EAS Enhanced Air Separator (A 600A)
- Air Management for Hydronic Heating and Cooling Systems (A 307B)
Installation/Operation Manuals
Parts Lists
Submittals
General Selection Tools:
- ESP-PLUS for B&G Centrifugal Pumps, Booster Pumps, Pump Accessories, and Air Separator
- ESP-PARTS for replacement parts selection
- ESP-TANKS for replacement parts selection
- CAD Drawings for 2D and 3D dimensional drawings in many formats
Heat Exchanger Product Selection
Steam + Water Pressure Reducing Values
- Steam-2000 Pressure and Temperature Regulator
- Steam-1140 Temperature Regulator
- Water-1140 Temperature Regulator
- Steam-Traps
Sizing Tools:
Report Bugs/Request Enhancements
Please email the following address to report issues and request enhancements: ebusiness.support@xyleminc.com
Consult your local Bell & Gossett Representative for additional assistance.
Regional Office:
Search below to find your local distributor. If there is no location found, please contact our regional office for more information.